Kenmore Dishwasher Repair in Tampa Bay
We fix Kenmore dishwashers at your home in Pasco, Hillsborough and Pinellas counties. Call with the model number and the error code, if there is one, and the technician will bring parts that fit.
Fix Now Appliance is an independent repair company, not affiliated with or authorized by Kenmore. Kenmore is a trademark of its owner, used here only to describe the appliances we repair.
Kenmore dishwasher error codes
What the code on the display usually means. Codes differ between models and years, so if yours isn't here or the meaning doesn't match, call and read it to us.
| Code | What it usually means |
|---|---|
| F2E2 | UI disconnect. Lack of communication between the User Interface and the Electronic Control Board. |
| F4E1 | Water heating error. The dishwasher isn't heating the water properly. Often a faulty heating element. |
| F5E1 | Door switch failure. Door isn't latching correctly, preventing the dishwasher from starting. |
| F6E4 | Float switch open. Float switch is stuck in the "open" position: possible overflow or water level issue. |
| F7E1 | No heat. Similar to F4E1, this error code points to a problem with heating the water. Often a failed heating element or thermostat. |
Common Kenmore dishwasher problems
Water left in the bottom
A clogged filter or drain hose, a jammed drain pump, or a garbage disposal knockout plug that was never removed when the dishwasher was installed.
Dishes come out dirty
Clogged spray arms or filter, water that isn't hot enough, or a weak wash pump.
Leaking
A worn door gasket, a cracked spray arm, a leaking inlet valve, or regular dish soap used by mistake.
Won't start or stops mid-cycle
A door latch switch, the control board or a thermal fuse.
Check these before you call
If one of these fixes it, you don't need us.
- Pull out and rinse the filter at the bottom of the tub. Many models need this every month.
- Run the kitchen tap until it's hot before you start a cycle.
- If it was just installed and won't drain, check the knockout plug in the garbage disposal inlet.
- Check the breaker, and the wall switch under the sink if you have one.
Repair or replace?
A leaking tub or a failed control board on an older, low-end dishwasher can cost more than replacing it. We'll quote first so you can decide.
Three steps, no surprises
- 1
Call or send a request
Tell us the brand, model and what's wrong. The technician brings the parts most likely needed.
- 2
Get a firm price
We find the fault and quote the exact cost before touching anything. The diagnostic is $89, and it comes off the bill if you go ahead with the repair.
- 3
Fixed and tested
Most repairs are done on the same visit. You pay after it's tested in front of you and get a written warranty.
Tell us what's wrong
Send the form and we'll call you back during business hours. In a hurry? Calling is faster.
(727) 425-27077 days a week, 8 AM–6 PM
fixnowappliance@gmail.comKenmore dishwasher repair questions
Are you an authorized Kenmore service center?
No. Fix Now Appliance is an independent repair company, not affiliated with Kenmore. If your Kenmore dishwasher is still under the manufacturer's warranty, call Kenmore first, because their warranty repair is free. Once it's out of warranty, we can fix it.
Why does a cycle take two or three hours?
Many newer dishwashers run that long on a normal cycle to save water and energy. That's by design, not a fault.
Why does my dishwasher smell?
Food stuck in the filter is the usual reason. Clean the filter and run a hot empty cycle with dishwasher cleaner.
Something stopped working?
7 days a week, 8 AM–6 PM. Most repairs done on the first visit.