Equator Washer Repair in Tampa Bay
We fix Equator washers at your home in Pasco, Hillsborough and Pinellas counties. Call with the model number and the error code, if there is one, and the technician will bring parts that fit.
Fix Now Appliance is an independent repair company, not affiliated with or authorized by Equator. Equator is a trademark of its owner, used here only to describe the appliances we repair.
Equator washer error codes
What the code on the display usually means. Codes differ between models and years, so if yours isn't here or the meaning doesn't match, call and read it to us.
| Code | What it usually means |
|---|---|
| E1 | Water supply error: machine is having trouble filling with water or the flow is too slow. |
| E2 | Drainage error: machine isn't draining properly or the drain pump is blocked. |
| E3 | Door not closed properly: door is open or not locked correctly. |
| E4 | Unbalanced load detected: load in the washer is unbalanced and needs adjusting. |
| E5 | Overheating error: motor or other component is overheating. |
| E6 | Water temperature sensor error: problem with the sensor that detects water temperature. |
| E7 | Motor error: problem with the washing machine's motor. |
Common Equator washer problems
Won't drain
A sock or coin stuck in the drain pump, a clogged pump filter or a kinked drain hose. Sometimes the pump motor itself has failed.
Won't spin, or spins slowly
Often a drain problem, because a washer won't spin with water in the drum. Otherwise a worn drive belt, motor coupling, lid switch or door lock.
Leaking
On front-loaders, a torn door boot or a loose pump hose. On top-loaders, a failed tub seal or a worn inlet hose.
Shaking or banging during spin
Worn shock absorbers or suspension rods, or a load that's badly out of balance.
Check these before you call
If one of these fixes it, you don't need us.
- Clean the pump filter. On most front-loaders it sits behind a small door at the bottom front.
- Make sure both water taps behind the washer are fully open.
- Check that the drain hose isn't kinked behind the machine or pushed too far into the standpipe.
- If it only smells, run an empty hot cycle with washer cleaner before calling anyone.
Repair or replace?
A failed transmission on an older top-loader or a worn drum bearing on a front-loader can cost close to a new machine. We'll tell you the price before you spend anything.
Three steps, no surprises
- 1
Call or send a request
Tell us the brand, model and what's wrong. The technician brings the parts most likely needed.
- 2
Get a firm price
We find the fault and quote the exact cost before touching anything. The diagnostic is $89, and it comes off the bill if you go ahead with the repair.
- 3
Fixed and tested
Most repairs are done on the same visit. You pay after it's tested in front of you and get a written warranty.
Tell us what's wrong
Send the form and we'll call you back during business hours. In a hurry? Calling is faster.
(727) 425-27077 days a week, 8 AM–6 PM
fixnowappliance@gmail.comEquator washer repair questions
Are you an authorized Equator service center?
No. Fix Now Appliance is an independent repair company, not affiliated with Equator. If your Equator washer is still under the manufacturer's warranty, call Equator first, because their warranty repair is free. Once it's out of warranty, we can fix it.
Why does my front-loader smell?
Water and detergent stay in the door boot and the drain. Wipe the boot, leave the door open after washing and use the right amount of HE detergent. If the smell stays, the pump filter or drain may need cleaning.
Can you fix a washer that's still under warranty?
Call the manufacturer first, because their repair is free. We can help once the warranty is over.
Something stopped working?
7 days a week, 8 AM–6 PM. Most repairs done on the first visit.